Filter
Top Products
HANDS-FREE PROGRAMMING & SETUP
NOTE: PASSIVE ARMING AND PASSIVE LOCKING MUST BE ENABLED ALONG WITH THE HANDS-
FREE MODE.
ENABLE HANDS FREE MODE:
1. Follow steps to enter Option Programming mode. (See page 7)
2. Press program button 1 time to get to option #1.
3. Press the Button #3 (Trunk Symbol) on the remote transmitter to enable this feature. System will chirp
3 times.
PROGRAMMING A HANDS FREE MODE:
NOTE: Hands-Free Remotes must be off for programming. See page 12.
1. Follow steps to enter Option Programming mode. (See page 7)
2. Press program button 21 times to get to Option #21.
3. Press the Button #3 (Trunk Symbol) on the remote transmitter to enable this feature. System will chirp
3 times.
4. Now press the button on the Hands-Free remote. System will chirp 3 times [again] as Hands-Free
remote is learned.
CAR JACK PROTECTION FEATURES
The anti carjack feature protects the driver from an intruder who entered the vehicle while the Ignition switch is
ON. When Carjack mode is enabled, a countdown begins each and every time the door opens with the
Ignition turned ON. If no action is taken to reset the countdown, the siren will begin to emit warning chirps after
90 seconds. At 105 seconds the 2008PC unit goes into a full car jack trigger for up to 4 minutes. During this
trigger, lights will flash, the siren sounds and starter is disabled. If the carjacker turns the vehicle OFF for any
reason, it will not restart. NOTE: For safety and liability reasons the Carjack protection cannot disable or shut
down an operating (traveling) vehicle.
RESETTING CARJACK:
• You MUST reset the carjack, countdown EVERY TIME a door is opened with the Ignition turned ON by
pushing the Valet button. Press the valet button if a door has been opened with the Ignition on. The
unit will flash the parking lights once indicating the Carjack countdown was reset.
• TO reset a FULL Carjack Trigger: Ignition must be ON, then press and hold Valet button for at least 10
seconds.
PROGRAMMING CARJACK:
1. Follow steps to enter Option Programming mode. (See page 7)
2. Press program button 11 times to get to Option #11.
3. Press the Button #3 (Trunk Symbol) on the remote transmitter to enable this feature. System will chirp
3 times and Carjack will now be enabled.
CARJACK WITH HANDS FREE REMOTE:
The 2008PC system can also be programmed to have the Carjack protection feature work in conjunction with
the “Hands-Free” remote transmitter described on pages 12 & 13. If you program “Hands-Free Carjack” then a
Carjack countdown will be triggered when the unit no longer receives the signal from the Hands-Free Remote
control.
PROGRAMMING CARJACK:
1. Follow steps to enter Option Programming mode. (See page 7)
2. Press program button 12 times to get to Option #12.
3. Press the Button #3 (Trunk Symbol) on the remote transmitter to enable this feature. System will chirp
3 times and Hands-Free Carjack will now be enabled.