Filter
Top Products
ALARM OPERATION
PANIC FEATURE:
In the event of an emergency situation or to attract attention to your vehicle, press and hold Button #4 (Panic).
The Siren will sound and lights will flash for 30 seconds. Press Button #2 (Unlock) reset.
ONE-TIME SHOCK SENSOR BYPASS:
To arm the system and bypass the shock for just that one time, press button #1 on either remote to arm,
then within 10 seconds press Button #1 AGAIN. Siren will chirp 5 times and lights will flash 5 times.
VALET MODE:
To disable the Alarm functions of the system while still allowing door lock/unlock, turn the ignition ON and
press the override/program button until the dash LED turns on solid and you hear a siren chirp (about 5
seconds). Repeat the same step to exit valet mode.
EMERGENCY OVERRIDE:
If you have lost the transmitter or it stops working for any reason and the Alarm is armed, you will have to
perform an emergency override to disarm the system. Open the door with the key, (alarm will sound) turn the
Ignition ON, and press and hold the override/program button at least 5 seconds. The Alarm will disarm and
enter the Valet mode to allow you to use the vehicle. You can repair/replace the remote or see your installing
dealer for assistance.
OPEN ZONE ALERT/BYPASS:
If the system detects a faulty or open zone (Door left open) when the system is ACTIVELY ARMED, the siren
will chirp (4) times, give (4) light flashes, and the faulty zone will be automatically bypassed.
TRUNK POP - AUX CHANNEL #1: (Optional)
To pop the trunk or activate an auxiliary feature, press button #3 (Trunk Symbol) on the remote for at least 2
seconds. The trunk pop feature is recommended for vehicles equipped with a Factory Electric trunk release.
Extra parts and/or labor may be necessary for this feature. If the system is armed, pressing Button #3 may
or may not also disarm the alarm system depending on programming option #17 configuration.
AUTOLOCK & UNLOCK WITH IGNITION: (Programmable)
The system is programmed to automatically lock when the ignition is turned on and unlock when the ignition is
turned off. Both the “Ignition Lock” and “Ignition Unlock” features can be turned ON or OFF individually
through the programming options of this system. See page #8.
ONE-TIME PASSIVE ARMING DISABLE:
To disable passive arming just one time, arm the system then quickly disarm within 10 seconds.
PASSIVE ARMING / PASSIVE LOCK MODES: (Programmable)
If programmed for passive (Automatic) Arming, the system will Arm itself 30 Seconds after the ignition is turned
off and the last door has been closed. The LED will begin flashing rapidly while counting down to Passively
Arm. If a door is open or reopened during the countdown, the system will wait (LED solid) for the door or zone
to close before arming. Upon Passive arming, the unit will chirp once and flash the lights once just like arming
with the remote. If Passive Locks are programmed ON, then doors will also lock. The 2-Way remote will also
receive a confirmation signal when the system passively arms. Note: Passive Arming may qualify for
insurance discounts-check with your agent or proprietor. The Passive locking feature increases the
risk of locking keys inside the vehicle.
AUXILIARY CHANNEL #2: (Optional)
Press button #5 (Side button) first, then press button #3 (Trunk symbol).
ACTIVE RE-ARMING:
Active Re-arming allows the system to re-arm itself 30 seconds after it is disarmed with the transmitter in the
event that a door has not been opened. This is handy if the vehicle is accidentally disarmed without your
knowledge (Remote is pressed while in your pocket/purse). This feature can be turned off with the
programming options.