Filter
Top Products
ALARM OPERATION
DOME LIGHT ILLUMINATION: (Optional)
This feature turns on the vehicle’s dome light upon disarm for 30 seconds or until the key is inserted and
turned on. This will provide illuminated entry to your vehicle at night or in dimly lit areas for safety and security.
FAULTY ZONE BYPASS:
When the system arms (actively or passively) with an “open” or faulty zone you will be alerted 4 siren chirps
and 4 light flashes. Once the open zone is closed it will be monitored by the alarm. If the zone never closes,
the alarm will stayed armed continuing to protect all other zones.
FAUTLY ZONE ELIMINATION:
If while armed, a faulty zone continue that continue to trip the system will be eliminated. The alarm will allow a
total of 4 cycles for the faulty zone (i.e. malfunctioning sensor). After 4 cycles, that zone will be eliminated.
REMOTE-LESS DISARM “Beach Mode”
NOTE: (3) Options: #1-Passive Arming, #8-Passive Locks and #9-Beach Mode must be enabled to use
this feature. See pages 7-10 for option programming information.
This feature allows you to disarm your system with the use of the Ignition Key and a 10 second entry delay
without the use of a your remote control. This feature comes in handy if you are performing an activity where
you do not want the remote control on your person i.e. swimming, boating, beach etc.
1. When leaving your vehicle passive arming will occur. (Keys in hand, no remote)
2. When you return to your vehicle open your door manually and enter your vehicle. A 10 second entry
delay is activated upon door opening and the siren will begin to chirp.
3. Insert key into the Ignition and turn to the ON position to disarm the alarm. If the key is not turned on
within 10 second (i.e. Intruder) then your system will go into a full alarm trigger.
PRIOR INTRUSION ALERT (DIAGNOSTIC)
This system includes disarm diagnostics, (through the RED LED light), that will help in determining what
caused the last trigger of the alarm system. This is a valuable tool in determining what was tampered with or if
there is a false alarm problem in which case you can make the necessary adjustments to correct the problem.
When the system is disarmed with the remote you will hear the 3 chirps and (3 Light flashes) that indicates the
alarm was triggered while you were away. When the IGNITION is turned ON, observe the LED light for a total
of 5 sequences:
LED FLASHES VIOLATED ZONE
1 Optional Sensor #2
2 Shock Sensor
4 Door
5 Trunk
6 Hood (with Remote Start
expansion module)
7 Not Used
8 Not Used
9 Carjack Trigger
10 12V power interrupted