Filter
Top Products
OPTION RESET
TO RESTORE ALL PROGRAMMABLE OPTIONS TO DEFAULT VALUES (*):
1. Turn the Ignition ON and press the Program/Override button 5 times. The siren will chirp 3 times indicating
you are in programming mode.
2. Press the #3 Button (Trunk Symbol) on the Transmitter. The system will chirp (6) six times indication all
options have been reset to Default values (Column #1).
CUSTOMIZED PERSONAL OVERRIDE CODE
Custom override allows the user to set a specific number of button presses (2 to 15) required to perform an
emergency override/disarm of the alarm system. This helps to defeat the common knowledge a thief may
have: If you turn the vehicle’s ignition on and press the valet button, most alarms will shut down. This feature
increases the level of security of your alarm system, however MUST MEMORIZE how many button presses
you have changed your system to use or the unit will not disarm in an emergency!!!
1. Follow steps to enter Option Programming mode. (See pages 7 & 8)
2. Press program button 4 times to get to option #4.
3. Press the Button #3 (Trunk Symbol) on the remote transmitter. System will chirp 3 times.
4. Now Press and release the program again the number of times you desire in order to perform emergency
disarm on this alarm system. Press the program button 2-15 times only.
To test feature: Set the alarm. Trip alarm system, turn key ON, press the program/valet button 2-15 times as
programmed above continuing to HOLD DOWN valet button on the LAST PRESS for 5 seconds. Alarm should
disarm. If system does not disarm, then disarm with the remote transmitter and try again. If system still does
not disarm, then repeat steps above.
“SECURE DISARM” FEATURE (Requires Wizard Installation Software)
Note: This feature can only be accessed and programmed using the Securlinc “Wizard” installation
software utility.
This feature prevents unauthorized use of your SecurLinc system even if the unauthorized user has the remote
control in hand. For example: If remote & keys are stolen. Secure Disarm allows you to program a specific
sequence of (4) button presses in order to actually disarm the system. The (5) button remote has 16
combinations which results in 65,536 possible sequences, thus guessing the correct sequnce that you have
picked is highly unlikely.
Operation:
1. When disarming your system, press your programmed button sequence. (The first button of the
sequence will disarm the system for 30 seconds, then the remainder of the button sequence must be
pressed or the system within the 30 second window or the unit will re-arm and/or trigger.
Programming:
1. From the “Installer Configuration Setting” menu of the Wizard, activate the “Disarm with button
sequence” option & Select the Download arrow to set the change into control unit memory.
2. Go to the remote configuration menu & select new remote.
3. Select the “new” icon. Press Button (1) once, then button (1) a second time to ID the remote.
4. Now a window will open with TX buttons and pull-down menu buttons.
5. The control module will allow you to choose your sequence by pressing each button.