OPTION PROGRAMMING
1. Turn the Ignition ON and press the Override/Program button 5 times. You should hear a long confirmation chirp.
2. Within the next few seconds, press the Override/Program button [again] the number of times that corresponds to
the feature list below. The siren will chirp for each button press. DO NOT LOSE COUNT!!
3. When you get to the desired option number, press the appropriate button on the transmitter according to the chart
below. Turn Ignition off. See Below for Option numbers, descriptions, and values. (Button 1 gives a single light
flash/chirp, Button 2 gives two light flashes/chirps, and Buttons (1+2) together gives three light flashes/chirps.)
4. Change ONE option at a time repeating steps 1-3 as needed. When you are finished customizing options, check
operation to see if the option(s) have changed.
PROGRAMMING OPTIONS CHART * = Default Settings
Option # Option Description BUTTON 1
LOCK
BUTTON 2
UNLOCK
BUTTONS (1+2)
TOGETHER
1. Factory Horn Chirps / Pulses Pulse with trip
only
Arm/Disarm Chirps
& Pulse with trip
Arm/Disarm/Warn Chirp &
Pulse with trip *
2. Passive Arming /
Passive Chirp Countdown
ON OFF* Passive Arm with
Chirp Countdown
3. Passive Lock / Cust. Override ON OFF* Custom Override
4. Ignition controlled Locks ON* OFF Ignition Lock Only
5. 10/60 Sec. Door Open Warning 10 Sec. 60 Sec.*
6. Active Re-Arm Enabled* Disable
7. Double Unlock Pulse Disabled* Enable
8. Silent Arm/Disarm
(Chirp Defeat w/Button 1)
Disabled* Enable
9. Parking Lights on with disarm Enabled* Disable
10. Disarm with trunk pop Disable Enabled*
11. Silent Arm/Disarm with Remote
(Button #2)
Enabled* Disable
12. Door Lock Pulse Time 0.7 Sec.* 3 Sec.
13. Type of Carjack Protection Active* Passive Full-Time
14. Carjack Features Enable/Disable Disabled* Enable
15. Arm/Disarm with Ignition ON
(**Overrides Carjack functions)
Disabled* Enable**
NOTE: Options can be instantly restored to Factory Default Values: To restore default values: Perform step #1 above,
then press buttons (1+2) together. The siren will chirp 4 times and lights will flash 4 times. Turn OFF Ignition. All
programming options should be restored to “*” values (See chart above).