Filter
Top Products
OPERATING INSTRUCTIONS
PASSIVE ARMING / PASSIVE LOCK MODES / PASSIVE CHIRP COUNTDOWN
If programmed, passive (Automatic) Arming will occur 30 Seconds after the ignition is turned off and the last
door has been closed. The LED will begin flashing rapidly while counting down. If a door is reopened, the
system will wait (LED solid) for the door or zone to close before arming. The unit will chirp once and flash the
lights once. Doors will lock if the “Passive Locking” feature is enabled. Passive Arm/Lock may qualify for
insurance discounts-check with your agent or proprietor. When the Unit is programmed for Passive Chirp
Countdown, the siren will chirp during passive countdown, as an audible warning that arming will occur. The
siren will chirp every 2 seconds as soon as the last door is closed until the system arms 30 seconds later.
DOME LIGHT ILLUMINATION (OPTIONAL)
This feature turns on the vehicles dome light upon disarm for 30 seconds or until the key is inserted and
turned on. This will provide illuminated entry to your vehicle at night or in dimly lit areas for safety and
security.
IGNITION-CONTROLLED DOORLOCKS
If this feature is enabled, the doors will automatically lock when the ignition is turned on and will unlock when
the ignition is turned off. This feature can be programmed on, off, or to lock the doors only. Doors will not
lock if they are open to prevent locking the keys in.
ACTIVE RE-ARMING (FAIL-SAFE PROTECTION)
The Active Re-arming feature allows the system will re-arm itself 30 seconds after being disarmed with the
transmitter if a door has not yet been opened. This is handy if the vehicle is accidentally disarmed (via the
transmitter in your pocket) without you knowing it. This feature can also be turned off in programming option
#6. If programmed for Passive Chirp Countdown, the unit will emit a chirp every 2 seconds until the system
Active Re-arms.
2
nd
AUX. OUTPUT (REMOTE AUX. OUTPUT 2)
To activate the Second auxiliary output press Buttons (1+2) together for (2) seconds. This output can be used
to control optional add-on accessories such as Remote Engine Start Modules, Window control modules, etc.
ARM/DISARM WITH IGNITION ON (PROGRAM OPTION #15)
This feature allows the system to be armed or disarmed while the ignition is in the ON position or vehicle is
running. The feature is disabled by default and should not be used under normal operating conditions. In
some rare instances where an add-on remote start module is used, this option can be enabled to allow the
CS-2000 alarm to be armed or disarmed when the vehicle is remote started (Ignition ON).