Crimestopper Security Products CS-2000 Automobile Alarm User Manual


 
OPERATING INSTRUCTIONS
ACTIVE ARMING
To arm the alarm and lock the doors, press the #1 Button
(Lock/Unlock Symbol) on the transmitter. You will hear a single
siren chirp and the lights will flash once. The system will arm, the
doors will lock and the starter will be disabled if these optional
features are installed. After a short 15 second delay to allow
vehicle and electronics to settle, the system will be completely
armed. The red LED in the vehicle will begin flashing.
ALARM TRIGGERING
If there is an intrusion into the vehicle or hard impact to the body
will sound the alarm and flash the lights for 45 seconds. After 45
seconds the system will automatically shut off and re-arm to
continue to protect the vehicle. If a door is left open, the unit will
cycle a second time and still continue to protect the other un-tampered zones.
2 BUTTON REMOTE TRANSMITTER:
Trunk
Pop
Arm/
Disarm
(Aux. 1)
Aux. 2
Button #1
Button #2
DISARMING
To disarm the alarm and unlock the doors, press the #1 Button (Lock/Unlock Symbol) on the transmitter. You
will hear 2 siren chirps and the lights will flash twice. LED stops flashing. Doors will unlock and dome light will
turn on if these optional features are installed.
TRUNK/HATCH POP (REMOTE AUX. OUTPUT 1, OPTIONAL)
To pop the trunk (if optional feature is installed), press Button #2 (Trunk Symbol) on the transmitter for at least
2 seconds. If the system is armed, pressing Button 2 may or may not trip the alarm system when opening the
trunk depending on programming option (10). See page 8.
REMOTE PANIC PROTECTION
To sound the alarm upon command (panic), press and hold Button #1 for at least 4 seconds until the siren
sounds. Press Button #1 again to reset panic mode.
PRE-WARNING SHOCK PROTECTION & SENSOR ADJUSTMENT
If a low-level shock to the vehicle is detected, pre-warning protection will activate sounding 6 quick siren chirps
and 1 light flash. If a hard impact is detected the shock sensor should trip the alarm system. Once it is
mounted, adjust the sensor as needed by turning the adjustment screw clockwise to increase or counter-
clockwise to decrease the sensitivity. The sensor is also equipped with 2 small indicator lights to ease the
adjustment process. Green light = Pre-warning disturbance (6 siren chirps). Red light = A full alarm trigger.