OPERATING INSTRUCTIONS
SILENT ARM/DISARM THROUGH REMOTE (BUTTON #2)
This system can be armed and disarmed without siren chirps on an “as needed” basis. Press and quickly
release Button #2 (TRUNK) to Arm and Disarm system without chirps. NOTE: If Button #2 is pressed too
long, then trunk pop may activate if optional Trunk-pop feature is connected to the system.
PROGRAMMABLE SILENT ARM/DISARM MODE
The system can be silently armed and disarmed as normal with the Lock/Unlock Button, without siren chirps.
See alarm programming option #8 on page 8 to enable or disable this feature.
EMERGENCY OVERRIDE & DISARM
If you have lost the transmitter or it stops working for any reason and the Alarm is armed, you will have to
perform and emergency override & disarm to shut the alarm off. Open the door with the key, (alarm will
sound). Turn the ignition on and press the override/program button 4-5 seconds (until siren stops). The Alarm
will disarm and enter the Valet mode, which allows you to use the vehicle until you can repair/replace the
remote transmitter or have the alarm system checked by an installer.
EMERGENCY DISARM WITH CUSTOM OVERRIDE
If you have programmed your system for Custom Override, follow the same steps above (Emergency
Override) while pressing the valet button 2-15 times as you have programmed. You must continue holding the
button down on the last press for at least 5 seconds.
VALET MODE
To disable the Alarm system for vehicle service or otherwise, turn the ignition on and press the
override/program button 4-5 seconds until the dash LED turns on solid and you hear (1) siren chirp. Repeat
the process to exit VALET mode and the system will chirp (2) times and the LED will turn off. Lock/Unlock and
AUX features will still operate in when in VALET mode.
PRIOR INTRUSION ALERT
If the system was tripped in your absence, the dash LED will be flashing rapidly. When the system is
disarmed you will hear 3 chirps (and 3 light flashes). Carefully inspect your vehicle to see if there is any
damage or a theft has occurred.
OPEN ZONE ALERT & BYPASS
If the system detects a faulty or open zone (Door left open) when the system is ACTIVELY ARMED, the siren
will chirp 4 times along with 4 light flashes. The faulty zone will be automatically bypassed.