Filter
Top Products
To enable valet mode
1. Turn the ignition switch to its “ON” position or start the engine.
2. Enter your secret valet code on the PlainView switch, then return the switch to its
center position.
3. You now have 3 seconds to press the latched position (valet mode). Once you have
entered valet mode, the system’s LED will glow continually for on-going visual
confirmation of valet mode.
Keyless entry in valet mode:
Even if valet mode is enabled, you can still remotely
control the convenience features. For instance, simply press button 1 (channel 1)
as if you were disarming. The doors will unlock (as indicated by one flash of the
parking lights) and the interior lights will illuminate. Press button 1 (channel 1)
again and the doors will lock (as indicated by two flashes of the parking lights).
You can also use the remote control’s other channels to activate options such as a
remote trunk release or remote engine starting.
To exit valet mode
1. Turn the ignition switch to its “ON” position or start the engine.
2. Flick the switch back to its center position. The LED will turn off to confirm that the
system is now in its normal operating mode.
NOTE: You can even enable or exit valet mode with your remote control from
outside the vehicle! See the Remote QuickAccess section on page 14.
Setting your own secret valet code
Since all IntelliGuard systems have the same factory-set code, it is highly advisable that
you set your own valet code. You may choose any 1-, 2-, or 3-digit code that does not
have any zeros. You can also change your valet code whenever you want. Simply write
down the 1-to-3 digit code you wish to use (remember, no zeros in the code), then refer
to the User-selectable features section on pages 20-22.
How to interpret the chirps and parking light flashes
When you use the remote control, the system responds with chirps (unless the chirp
muting feature is turned on) and parking light flashes. These chirp/flash
acknowledgments mean:
Chirps and flashes Meaning
1
Your IntelliGuard system is disarmed
2
Your IntelliGuard system is armed
2 and then 4
Armed but there is a door open (if there was a 5-sec. delay) or the sensor is
malfunctioning (if there was a 10-sec. delay) (see Smart AutoTesting on page 16)
3
Disarmed but there was an intrusion attempt while you were away
(see Smart Prior Intrusion Attempt on page 17)
4
Armed but the hood or trunk is ajar (see Smart AutoTesting on page 16)
12