Filter
Top Products
MS2007 Owner’s Manual - Page 11
3. Release the brake pedal.
4. Remove the key from the ignition switch.
5. You may now exit the vehicle, arm the alarm and lock the doors.
To re-enter the vehicle and resume driver control:
1. Disarm the alarm by pressing Button 2 on the Remote Transmitter.*
• The doors will unlock.*
2. Turn on the ignition.
3. Press the brake pedal to disengaged the MS2007.
• The LED will turn off.
*If optional keyless entry feature is installed.
Auto Cold Starting
The Auto Cold Starting Feature automatically starts the vehicle every two hours and runs for the
preset Run Time.
To enter Cold Start Mode:
1. Be sure ignition is off.
2. Press and hold the Valet switch.
3. Continue holding the Valet switch and press Transmitter Button 3 for 5 seconds then
release both buttons.
• The parking lights will flash 5 times.
• The engine will start and run for 30 seconds then shut down.
• The LED will flash.
4. The system will remain in Cold Start Mode until the vehicle is started using the transmitter
or the Cold Start Feaure has completed all the run cycles.
Note: Pressing the brake pedal will also turn off the Auto Cold Starting Feature.
MS2007.qxd 09/24/2002 1:24 PM Page 11