Filter
Top Products
Page 10 - MS2007 Owner’s Manual
Remote Starting
To Remote Start the System:
1. Be sure the System is not in Valet Mode.
2. Press Button 4.
• The LCD will show .
• The parking lights will turn on.
• The siren will chirp 3 times (if the system is Armed, the shock sensor will turn off).
• The ignition will turn on.
• The engine will start and run for the duration of its programmed Run Timer.*
• The heater or air conditioner will turn on (if turned on prior to exiting the vehicle).
• The LED will flash rapidly.
• The LCD will show .
*If the engine fails to start on the first attempt, it will repeat the starting procedure 2 more times.
Turning on the ignition key then pressing the brake pedal will disengage the MS2007 and allow
you to operate and drive your vehicle in a normal manner.
Shut Down
Any of the following will shut down the engine when it is under Remote Start control:
1. Press Button 4 for 3 seconds.
• After the engine shuts down the doors will lock (if installed and programmed).
• The LCD will show .
2. Press the brake pedal.
3. Open the hood (or trunk if connected).
4. Remote Start Time-Out (completion of the timed run cycle).
Stop and Go
The Stop and Go Feature allows you to remove the ignition key and exit the vehicle while keeping
the engine running during short stops.
To leave the vehicle running:
1. Press the brake pedal and hold.
2. While pressing the brake pedal, push Button 4 on the Remote Transmitter for 2 seconds.
• The LED will flash rapidly.
• The parking lights will flash 5 times.
Remote Start Features
MS2007.qxd 09/24/2002 1:24 PM Page 10