Filter
Top Products
MS2007 Owner’s Manual - Page 7
• The LCD will show and .
• The LED will turn off.
* The siren chirps and light flashes during disarming will alert you if the system had been triggered while armed.
2 chirps / 2 flashes = normal disarming
3 chirps / 3 flashes = Tamper Alert - system was triggered
** If the Passenger Unlock Feature is installed, pressing Button 2 will unlock only the driver’s door. Pressing the
unlock Button 2 again unlocks all doors.
Tamper Alert
On Disarming, if the system responds with three chirps, indicating the system was triggered, the
LED will flash for 60 seconds to indicate the zone that triggered the system.
1 flash = door
2 flashes = shock sensor
3 flashes = trunk
example: flash-flash-pause-flash-flash-pause = shock sensor
Silent Arming / Disarming
Each Remote Transmitter can be individually set to Arm and Disarm the system with or without
chirp confirmation at the time they are programmed into the system (see Adding a New
Transmitter into the System).
To mute the Arming and Disarming confirmation chirps, you can Arm or Disarm the system by
pressing Button 3.
Note: The confirmation chirps will only be cancelled if the system status is normal. The chirp indications for Tamper
Alert and the open zone warning will not be cancelled when the system is Armed or Disarmed silently .
Arming Mode Selection
The system can be set in one of the following Arming Modes:
• Passive (automatic) Arming with chirp confirmation
• Active Arming (by Remote Only)
• Passive (automatic) Arming without chirp confirmation
To set the Arming Mode:
1. Turn the ignition on.
2. Within 4 seconds, press the Transmitter button corresponding to desired operation.
Button 1 / 1 chirp = Active Arming
Button 2 / 2 chirps = Passive Arming with chirp
Button 3 / 3 chirps = Passive Arming without chirp
Note: If no buttons are pressed for 5 seconds, Arming Mode Selection is automatically exited.
3. Turn the ignition off to save the selection.
MS2007.qxd 09/24/2002 1:24 PM Page 7