Filter
Top Products
Removal
1. Secure the cover (A)
into the open position.
2. Loosen wing bolts (B)
on both driver and
passenger side of front
rail, then slide latches
inboard until released
from the side rail.
3. Pick the cover
assembly up on
the driver side and
pull the whole
assembly off the
truck box.
Adjustment
1. If the cover is too
loose, turn the
tensioning screw
clockwise to tighten the
tension of the vinyl.
This makes it harder to
operate the rear
release latch. The
tensioning screws are
located on each side
rail. Use the provided
1/4 inch key to turn the
tensioning screws.
2. Adjust the screws on both sides to the same
tension.
3-13