Filter
Top Products
6. Tighten the clamp by turning the latch (C) toward
the side rail. Make sure there is no gap between
the rubber clamp pad and the side rail.
7. If the truck box has a molded bed rail protector,
insert the latch into the top notch on the inner
clamp.
8. Clean the vehicle's painted surface below the pull
strap using a 50/50 mixture of rubbing alcohol and
tap water.
9. Remove the paper from the provided clear tape
strip and apply to the painted surface below the
pull strap.
Adjustment
If there is excessive sideways movement of the
crossrails, move and re-install the clamps on the
loose areas using the inner groove of the clamp.
3-9