Filter
Top Products
To experience the performance benefit of this
system, after entering a curve and at the point where
the driver would normally start to increase acceleration,
the accelerator pedal can be fully pressed. The
Performance Traction Management system will modify
the level of engine power for a smooth and consistent
corner exit.
To select a mode while in
Performance Traction
Management, turn the
knob located on the
console.
The Performance Traction Management system
contains five modes. These modes are selected by
turning the Selective Ride Control/Performance Traction
Management knob on the center console. The driver
scrolls up or down through modes 1-5 by rotating the
knob to the right or left.
The following is a DIC display description and the
recommended usage of each mode:
PERF TRAC 1 – WET ACTIVE
HANDLING ON
.
Intended for all driver skill levels
.
Wet or damp conditions only — not intended for
use in heavy rain or standing water
.
Active Handling is on and engine power is reduced
based on conditions
PERF TRAC 2 – DRY ACTIVE
HANDLING ON
.
For use by less experienced drivers or while
learning a new track
.
Dry conditions only
.
Active Handling is on and engine power is
slightly reduced
5-11