Filter
Top Products
4. If necessary, use the flat end of the wheel wrench
to pry along the edge of the wheel cover until it
comes off.
Store the wheel cover in the trunk until the flat tire
is repaired or replaced.
5. Use the wheel wrench to loosen all the wheel nuts
on the flat tire. Do not remove them yet.
6. Position the jack lift head at the jack location
nearest the flat tire. The front location is about
8 inches (20 cm) behind the front wheel opening.
Notice: Make sure that the jack lift head is in the
correct position or you may damage your vehicle.
The repairs would not be covered by your warranty.
7. Raise the jack head until it fits firmly in the
vehicle's frame, where the notch is located,
nearest the flat tire.
8. Put the tire near the flat tire.
{
WARNING:
Getting under a vehicle when it is jacked up is
dangerous. If the vehicle slips off the jack, you
could be badly injured or killed. Never get under
a vehicle when it is supported only by a jack.
6-108