Filter
Top Products
Notices for Customer-Installed
Equipment
Read the following notices before installing equipment
on your specialty vehicle.
Notice: GM-approved service procedures must be
followed to remove and reinstall the instrument
panel to the pad in order to ensure proper airbag
deployment.
Notice: Do not mount equipment on the passenger
side of the instrument panel top pad deployment
zone. Equipment should not be mounted on or
around the passenger airbag opening because of a
deploying airbag. To allow the airbag to perform as
it was designed, do not mount equipment inside the
airbag deployment zone.
Notice: Your police vehicle may have optional
roof-rail airbags. Do not mount a security barrier
such that the ends of the barrier or brackets are
within the roof-rail deployment zones.
Notice: Your police vehicle may have roof-rail
airbags and a rollover sensor. The rollover sensor is
mounted on the centerline of the vehicle between
the driver and right front passenger positions.
If your vehicle has bucket seats, the rollover sensor
will be exposed. Do not mount equipment within
25 mm (1 in) of the rollover sensor. This may affect
the performance of the airbag system. To allow the
airbags to perform as they are designed, do not
mount equipment near this area.
Notice: Avoid installing wiring for roof-rail
emergency lighting or radio antennas that may
restrict the proper deployment of the roof-rail
airbags.
2-5