Filter
Top Products
Auxiliary Battery Power Junction
Block(s)
Two auxiliary power junction blocks are located
within the driver's side rear cargo area jack stowage
compartment. Each junction block is powered directly
from the battery through a 50 amp circuit breaker for
connection to customer‐furnished equipment. The two
circuit breakers are located in the breaker/relay panel
forward of the instrument panel glove box. A maximum
load of 50 amps (600 watts) can be connected to each
junction block. The wiring diagram for this circuit
is shown as part of the diagram for “Wiring
Provisions ‐ 12 Volt Battery Power”.
The two junction blocks are connected to coiled
5 foot (1.5 m) branches of the rear body harness and
fastened near the jack. Mounting of the junction blocks
can be at customer‐selected rear cargo area locations
permitted by the branch harness length and using
customer‐furnished mounting hardware.
The junction blocks should not be attached to the
interior trim plastic components without appropriate
backing hardware to the mounting bolts.
15-20