Filter
Top Products
Wiring Provisions for Front
Speakers - SEO WX7
About 65 inches (165 cm) of auxiliary speaker wire is
run from the instrument panel radio connector and is
coiled under the center of the instrument panel. The
wiring permits the connection of front door speakers to
customer-installed communication equipment.
Radio outputs from the front speakers are sent to the
rear speakers to maintain the required open door/key in
the ignition reminder chime
Electrical Connections
1. Disconnect the negative (−) battery cable at the
battery.
2. Remove the tape from the wire coiled under the
instrument panel to uncoil it.
3. Using proper electrical connectors, connect the
wires for the left front audio output of the
customer-installed communication device.
The left front positive wire is tan and the left front
negative wire is gray.
4. Using proper electrical connectors, connect the
wires for the right front audio output of the
customer-installed communication device. The
right front positive wire is light green and the right
front negative wire is dark green. The electrical
impedance of each speaker installed is 10 ohms.
Notice: Overloading the vehicle's electrical system
may damage your vehicle's accessories. Do not
overload the vehicle's system by having
unnecessary accessories on at the same time.
5. The ignition must be turned off and the vehicle
must be vacated prior to attaching the cable to the
battery. Connect the negative (−) battery cable to
the battery and tighten the bolt to 3.7 lb ft (5 N·m).
6. Set the time on the clock and radio pushbuttons as
needed. See “Audio Systems” in the Index of the
vehicle's owner manual for more information.
15-10