Filter
Top Products
SEOs Available with Police
Package and Special Service
Package
Exterior Lamp Emergency Flashing
System - SEO 6J7
SEO 6J7 provides a high-beam headlamps flashing
module, rear lamps flashing and control wire for a
customer-furnished switch to turn the module on or off.
The flasher control wire is coiled under the center of the
instrument panel. This control lead may be combined
with the interior wiring leads for SEO 6J3 when that
option is ordered with SEO 6J7.
The headlamps flashing module is located below the
passenger side front headlamp and forward of the
passenger side front wheel. The module is connected
to an inline connector in the forward lamp harness.
The headlamps flashing module is activated by the
application of 12 volts to a dark green/red wire coiled in
the passenger side footwell. When activated, the driver
and passenger side high-beam headlamps and the
high-beam instrument panel cluster light will flash
alternately at 2.4 flashes per second.
When the headlamps flashing module is turned on,
the module sends a signal to the Body Control Module
(BCM). The BCM alternately flashes the stop lamps and
backup lamps. Depressing the brake pedal will override
the stop lamp flashing and placing the transmission in
reverse will override the backup lamp flashing.
During daylight conditions, the Daytime Running
Lamps (DRL) are automatically turned off whenever
the headlamps flasher module is activated. During
nighttime conditions, the low-beam headlamps turn on
automatically while the high-beam headlamps flash.
Turning on the high-beam headlamps manually with the
turn signal/multifunction lever will override the flashing
module and the high-beam headlamps will operate
continuously.
15-2