Filter
Top Products
If your child restraint has the LATCH system, see Lower
Anchors and Tethers for Children (LATCH) (Z06
Models Only) on page 1-35 or Lower Anchors and
Tethers for Children (LATCH) (Coupe and Convertible
Models Only) on page 1-39 for how to install your
child restraint using LATCH. If you secure a child
restraint using a safety belt and it uses a top tether, see
Lower Anchors and Tethers for Children (LATCH)
(Z06 Models Only) on page 1-35 or Lower Anchors and
Tethers for Children (LATCH) (Coupe and Convertible
Models Only) on page 1-39 for top tether anchor
locations.
Do not secure a child seat in a position without a top
tether anchor if a national or local law requires that the
top tether be anchored, or if the instructions that
come with the child restraint say that the top strap must
be anchored.
In Canada, the law requires that forward-facing child
restraints have a top tether, and that the tether be
attached.
You will be using the lap-shoulder belt to secure the
child restraint in this position. Follow the instructions that
came with the child restraint.
1. Move the seat as far back as it will go before
securing the forward-facing child restraint.
When the passenger sensing system has turned off
the right front passenger’s frontal airbag and
seat-mounted side impact airbag (if equipped), the
off indicator on the passenger airbag status
indicator should light and stay lit when you start the
vehicle. See Passenger Airbag Status Indicator
on page 3-36.
2. Put the child restraint on the seat.
3. Pick up the latch plate, and run the lap and shoulder
portions of the vehicle’s safety belt through or
around the restraint. The child restraint instructions
will show you how.
1-41