Filter
Top Products
Each higher setting provides more volume compensation
at faster vehicle speeds. To turn automatic volume off,
press this until AUTO VOLUME OFF displays.
If your vehicle has the Bose
®
audio system, it includes
Bose
®
AudioPilot
®
noise compensation technology.
When turned on, AudioPilot
®
continuously adjusts the
audio system to compensate for background noise, so
that the music always sounds the same at the set volume
level. This feature is most effective at lower radio volume
settings where background noise can affect how well you
hear the music being played. At higher volume settings,
where the music is much louder than the background
noise, there could be little or no adjustments by
AudioPilot
®
.
To use AudioPilot
®
, set the radio volume to the desired
level. Turn AudioPilot
®
on by pressing the automatic
volume button until AVOL ON displays. As the vehicle
goes faster, the background noise increases. AudioPilot
®
adjusts the audio system’s sound level to overcome
background noise. To turn AudioPilot
®
off, press the
automatic volume button until AVOL OFF displays.
For additional information on AudioPilot
®
, visit
www.bose.com/audiopilot.
MUTE: Press to silence the system. Press again to turn
the sound on.
This button is not available on the Radio with
Six-Disc CD.
Finding a Station
BAND: Press to switch between AM, XM1 or XM2
(if equipped), FM1, or FM2. The display shows
the selection.
O / e (Tune): Turn to select radio stations.
t SEEK u: Press the arrows to go to the previous
or to the next station and stay there.
The radio only seeks stations with a strong signal that
are in the selected band.
t SCAN u: Press and hold either arrow for
two seconds until FREQUENCY SCAN displays.
The radio goes to a station, plays for a few seconds,
then goes on to the next station. Press either arrow
again to stop scanning.
To scan preset stations, press and hold either arrow for
four seconds until PRESET SCAN displays. The radio
goes to the next preset station, plays for a few seconds,
then goes to the next preset station. Press either arrow
again or one of the pushbuttons to stop scanning presets.
The radio only scans stations with a strong signal that are
in the selected band.
3-84