Filter
Top Products
21
4.0 OPERATING INSTRUCTIONS
While the VX402C-64 is an active carrier, it is designed to be completely transparent to the host
interface. For this reason, the VME module can be accessed as if it were plugged directly into
the host backplane.
In order to operate the VME module, first set up the hardware configurations on the VX402C-64.
Then set the necessary trigger directions using the switches. Ensure the jumpers are set for proper
SUMBUS signal routing. Install or remove the pass-through connector cable as desired and
replace the shield if necessary.
The unit is now ready to be inserted into the chassis. Next, install the VME module into the front
connectors of the VX402C-64. Once power is applied, the VME module can be readily accessed
as if it were plugged directly in the backplane.
C&H Technologies, Inc. <> 445 Round Rock West Drive <> Round Rock, TX 78681 <> www.chtech.com