Filter
Top Products
10
Car Finder
While the system is armed, press and release Button #3. The alarm will chirp 6 times and the parking lights
will flash. This is used to locate your vehicle in a crowded parking lot.
Optional Accessories (Trunk Pop, etc., Opt. Part #775 required)
NOTE: When the alarm is disarmed, press Button #3 and the trunk will open. When the alarm is armed, press
and hold Button #3 for 2 seconds or until the trunk opens. If Button #3 is pressed and held, a ground output
signal is applied to the connected accessory for as long as this button is pressed. CAUTION: When opening
the trunk while the system is armed, shock and current sensing will shut off.
Instant Personal Panic
Press and release transmitter Button #4 to sound the instant panic siren. The lights and siren will activate
for 30 seconds and then shut off. To stop the siren before the 30 seconds, press any of the 4 transmitter
buttons.
LED Status Indicator
The LED (red light) provides valuable information about the system and is also a theft deterrent.
LED Status LED Display
Armed Flashing Slow
Disarmed Off
Passive Arming Flashing Fast (arming count down)
Valet Constantly On
Violated Zone Triggered Device # of Flashes
Zone 2 On Board Shock Sensor 2 Flashes
Zone 3 External Sensors 3 Flashes
Zone 4 Voltage Sensor 4 Flashes
Zone 5 Door Switches 5 Flashes
Zone 6 Ignition 6 Flashes
Plug In Override Switch
In the event your remote control is lost, damaged or malfunctions; this switch allows you to disarm your system.
You must first open the door to the vehicle, turn ignition to the "ON" position, then press the override
switch. The siren will silence and you will now be able to start the engine. NOTE: A door must remain open
during this procedure.
Anti-Carjacking Protection
We strongly recommend you use this feature only in unsafe neighborhoods. To activate the anti-carjacking system,
flip the toggle switch forward to the "ON" position. To turn the anti-carjacking system off, switch the toggle
backward to the "OFF" position. If any door is opened and then shut when the anti-carjacking switch is in
the "ON" position and the engine is running, the siren will sound and the lights will begin to flash in one
minute. If the engine is shut off it will not restart. If activated, to turn off the anti-carjacking you
must turn the ignition off, flip the toggle backward to the "OFF" position and then press Button #1 on the
transmitter. We recommend turning the anti-carjacking off when in safe areas. The 1 minute time delay allows
you to leave the area of danger and later makes the car undriveable for the carjacker. Unlike a normal violation,
the alarm will not reset after 30 seconds. The siren will continue to sound and the lights will continue to
flash until the proper deactivation steps have been performed. To deactivate the anti-carjacking protection,
turn the ignition switch off, flip the toggle backwards or to the "OFF" position, then press transmitter
Button #1. The siren will chirp twice, confirming that the anti-carjacking protection is disengaged. You may
now start the engine. NOTE: If you accidentally activate the anti-carjacking protection, you may deactivate
it before or after the siren sounds. (IT MUST BE DONE WITHIN 1 MINUTE OR THE SIREN WILL SOUND.)
CAUTION: DO NOT TURN ON THE DOME LIGHT WHILE THE ANTI-CARJACKING PROTECTION IS ENGAGED. THIS WILL ALSO ACTIVATE
THIS PROTECTION FEATURE.
Automatic Passive Arming
To program Automatic Passive Arming On, disarm the system, press and hold Button #3 for 10 seconds, until the unit
chirps once. Release Button #3 then press and release Button #3 again within (2) two seconds. The system will chirp
once again to indicate that Passive Arming is now programmed ON. NOTE: Factory setting is Automatic Passive Arming
Off.
Automatic Passive Arming with Door Locks On
To program Automatic Passive Arming with Door Locks On, disarm the system, press and hold Button #3 for 10 seconds,
until the unit chirps once. Release Button #3 then press and release Button #3 again within (2) two seconds. The
system will chirp once. Press and release Button #3 again and the unit will chirp twice. The Automatic Passive
Arming with Door Locks is now programmed.
Passive Arming Off
To program Passive Arming Off, disarm the system. Press and hold Button #3 for 10 seconds, until the unit chirps
once. Press and release Button #3, the unit will chirp three times. Passive Arming is programmed Off.
High Theft
To program High Theft On, press Button #2 within two seconds after arming the unit, the system will chirp once (or
flash the parking lights once if Silent Arming is activated). The High Theft feature will only function for this
OPERATING INSTRUCTIONS