Filter
Top Products
9
WIRING DIAGRAMS
FIGURE 1
8 7 6 5 4 3 2 1
16 15 14 13 12 11 9
BLUE
:
WHITE
:
MAIN CONNECTOR
1. Red (+) 12 Volt Constant
2. Black Chassis Ground
3. Grey (+) Siren Output
4. White/Red Button #3 / Channel #3 (-) Output: Window Rollup,
etc. 200 mA Max
5. White/Yellow Button #2 / Channel #2 (-) Output: Remote Starter,
etc. 200 mA Max
6. Brown/Black Not Used
7. Green/Black Not Used
8. Orange (-) Output when armed: Starter Disable
9. Brown (+) Parking Light Output
10.Open
11.Green (-) Shock Sensor Input (minor): Warn Away /
10 Second delay after arming
12.Yellow (+) Shock Sensor Input (major): Triggers
Alarm / 10 Second delay after arming
13.Black/Blue (+) Door Pin Input /
20 Second delay after arming
14.Black/Yellow (-) Door Pin Input /
20 Second delay after arming
15.Violet (-) output dome light
supervision 300 mA max
16.Red/Black (+) 12 volt ignition sense input
RED
BLACK
5-Pin
Door Lock
Harness
Connector
Antenna
plug
HOW TO USE YOUR REMOTE TRANSMITTER
Arming
Press Button #1 to arm the system. The siren will chirp 1 time, the lights will flash once, the power door
locks will lock (if installed), and the LED will flash slowly indicating the alarm is now armed. The engine
starter is also disabled.
Disarming
Pressing Button #1 again will disarm the system. The siren will chirp twice, the lights will flash twice,
and stay illuminated for 30 seconds, acknowledging that the system is disarmed. NOTE: If you hear 3 siren
chirps and see 3 light flashes when disarming, the vehicle was violated while you were away. Check the
LED for zone violation. See Operating Instructions, page 18 for “Violated Zone” explanation. This is a good
time to check your vehicle for possible damage. When disarming, the dome light will turn on for 30 seconds
if the Dome Light Supervision feature is connected (optional, part #775 required).
Silent Arming/Disarming
Should you desire not to have the siren chirp when arming and disarming, press and hold Button #1 for 3 seconds.
The system will perform all its usual arming/disarming functions, except there will be no arming and disarming
chirps. If the alarm is triggered, the siren will provide its normally loud sound. NOTE: If the lights flash
3 times after disarming, the vehicle has been violated as described in Operating Instructions, see page 18
for “Violated Zone”.
Remote Car Starter (Optional equipment required)
A second channel built into this model can be activated while it is in the armed or disarmed mode. The second
channel can be used for remote engine starting (optional module required). Press Button #2 while the system
is armed or disarmed, the parking lights will flash once, and then will activate the installed accessory.
CAUTION: When remotely starting the vehicle while the system is armed from Button #2, shock and current sensing
will automatically shut off.
1
3
2
4
BULLDOG
BUTTON #2
OPTION #2
BUTTON #4
PANIC
BUTTON #1
ARM/DISARM
BUTTON #3
OPTION #3
BUTTON #2
OPTION #2
BUTTON #4
PANIC
BUTTON #1
ARM/DISARM
BUTTON #3
OPTION #3
BULLDOG