Filter
Top Products
19
© 2008 Directed Electronics—All rights reserved
3. In gasoline vehicles, the engine starts 4 seconds after the
parking lights flash. In diesel vehicles, the engine starts when
the WAIT-TO-START indicator on the vehicle's dash goes
out or the programmed delay has ended.
4. Once the vehicle has started, it runs for the pre-programmed
period of time (either 12, 24, or 60 minutes - see
Programming Options section of this guide) or until a shut-
down input is triggered.
When you are ready to drive the vehicle:
1. Insert the ignition key and turn
it to the ON (not START) posi-
tion.
2. Press the brake pedal.
While the vehicle is running during remote start operation, the
system will monitor the vehicle and will automatically shut down
the engine if the system receives any of the following shut-down
inputs:
➤ The brake pedal is pressed.
➤ The hood is opened.
Note: If the brake pedal is pressed before the key is in the
ON position, the engine will shut down.
IImmppoorrttaanntt!!
It is unsafe to operate a vehicle’s motor in a
garage or other closed off area. Breathing the exhaust
from the vehicle is hazardous to your health. Never acti-
vate the remote start in an enclosed space.
G5103_2008-06F.qxd 7/9/2008 10:39 AM Page 19