Filter
Top Products
Countdown Timer
This feature allows set up a countdown of a duration entered by the user in hours and
minutes using the
button (refer to the tables).
Parking Countdown
This version of the Countdown feature is particularly useful for keeping track of parking
meter time: the user may quickly set up the countdown in slices of 10 or 30 minutes using
the
and buttons (refer to the tables).
Melody Selection
The Remote Control allows the user to select which melodies are to be used upon the
following events: remote starting of the vehicle, the Alarm, ending of the countdown,
entering Cold Weather Mode. Melodies for these various events can be selected using the
button (refer to the tables).
Vibration Mode
Use this feature to replace audible signals with a vibration signal. Use the and
buttons to switch Vibration Mode ON and OFF (refer to the tables).
Power Saving Mode
When set to Power Saving Mode, the Remote Control will cease polling the Remote Starter
Module on a regular basis for status information. This will extend battery life. Use the
and buttons to switch Power Saving Mode ON and OFF (refer to the tables).
Remote Control Finder
This function allows the user to locate the Remote Control when it has been accidentally
dropped near the vehicle. Pressing the Valet Button and holding it down for 3 seconds (or
until the Parking Lights flash five times) will cause the Remote Control to start beeping for
one minute. The beeping will stop by itself after one minute, or it can be switched off by
pressing the Lock (
) or the Unlock ( ) button on the Remote Control.
Door and Hood Monitoring
The remote control will warn the user when any sensor zone is either open or under attack:
If a door is left open, the remote control will beep once and the door will start flashing on the
Vehicle icon of the display. After If the door is closed, the remote control will beep a second
time and the door image will stop flashing after five seconds.
If the hood is left unclosed, the remote control will beep once and the hood will start flashing
on the Vehicle icon of the display. After If the hood is closed, the remote control will beep a
second time and the hood image will stop flashing after five seconds.
If the alarm detects an intrusion either through a door or through the hood, the alarm will be
triggered. This event will be reported on the remote control by the Intrusion Icon (
) which
AS-6070 TW User Guide P. 5