Filter
Top Products
AS-6070 TW User Guide P. 15
Car Finder
(Enabled by default.) When enabled, the Car Finder option will help you locate your vehicle by
generating a pulsating signal through the horn or the siren. To hear the signal, press the
LOCK and
UNLOCK buttons simultaneously. This will cause a pulsating signal lasting for the time you keep the
buttons pressed.
Siren or Horn Chirp Timing
The duration of the chirps can be adjusted at installation (from 5 to 200 ms).
Safe Start
(Disabled by default.) If this feature is enabled, the user must press the
START/STOP button 2 times
within 3 seconds to remote-start the vehicle. This will eliminate accidental remote starts, e.g. when
children are playing with the transmitter.
If Swap Start Mode is selected, to remote-start your vehicle press
LOCK and UNLOCK
simultaneously. The AUX 2 output can be activated by pressing the START/STOP button.
Home Valet
TM
(Disabled by default.) If this feature is installed, the user will have the possibility to remotely set the
vehicle to a no-remote-start mode. See Home Valet section, earlier in this Guide, for full
instructions.
Ignition-controlled Door Locks
(Enabled by default.)This is an added security feature. If your Systems was installed with the
Ignition-Controlled Door Locks option, the doors will automatically be locked as soon as the ignition
key is turned to the
IGNITION ON (RUN) position while the brakes are pressed. When the key is turned
to the
OFF position, the doors will automatically be unlocked.
Ignition Re-lock
On Systems of this series, when Ignition-controlled Door Locks are enabled and the ignition key is
in the
IGNITION ON (RUN) position, should any door be unlocked and opened, all doors will be
relocked next time the brake pedal is pressed.
Secure Lock
(Disabled by default.) Before it can remote-start your vehicle, the System must first disarm the
factory security system. The Secure Lock feature may be required on certain vehicle models with
factory security systems that automatically unlock the doors when the security system is disarmed.
To keep your vehicle protected when the factory security system is disarmed for a remote start,
Secure Lock will relock your doors as soon as the vehicle has started. Once the engine run cycle
ends, Secure Lock will rearm your factory security system.
Turbo Mode
(Disabled by default.) When left in Turbo Mode, the System will keep the engine running for
60 seconds before shutting it down. This is to allow a turbocharger to idle down after the user
leaves the vehicle. See Turbo Mode section earlier in this Guide.
Remote Trunk Release
If your system was installed with the Remote Trunk Release option, you can open your trunk by
pressing the
TRUNK button for 3 seconds on the remote transmitter or by pressing the TRUNK button
TWICE within 3 seconds.
Engine Run Time
(15/20 minutes by default.) If you have a gas engine, your System can be programmed to run the
engine for 4, 15, or 25 minutes (15 minutes by default). If you have a diesel engine, the System
can be programmed to run the engine for 9, 20, or 30 minutes (20 minutes default).