Filter
Top Products
AS-1785 Installation Guide P. 9
Caution! If multiple relays or modules are
connected to the GROUND OUT WHEN RUNNING
wire, make sure they are diode isolated from one
another: feedback may otherwise occur, causing
damage to the vehicle.
This input should be used in vehicles with negative-
switching Door pins or Dome Li
g
ht circuits. Connect
to the Dome Li
g
ht wire that tests
g
round when a Doo
r
is open.
11 GREY
(–) Negative Doo
r
input
Caution! The installer should use either the positive
or the ne
g
ative Door input. Never use both of them
simultaneously.
It is essential that the Remote Car Starter be
connected in such a way as will allow each one of the
Doors to turn off Ready Mode: the driver-side Doo
r
Pin does not constitute b
y
itself a sufficient
connection.
12 YELLOW
(+) Glow-Plug
input
In Diesel Mode, this positive input will monitor the
Glow Plug Light: it will wait for up to 18 seconds
until the Glow-plug Light goes out before allowing
the Remote Car Starter to proceed to cranking the
Engine. Connect to the side of the Glow-plug Light
which is positive when the Light is on.
Note: the Remote Car Starter will nevertheless
proceed to cranking the Engine if the Glow-plug
Light is still on after the 18-sec. delay (25 sec.
when the Run Time is set to 30 min.).
A Note on the Diesel Glow-plug Indicator
Light: