Filter
Top Products
AS-1785 Installation Guide P. 11
12 YELLOW
(+) Glow-Plug
input
(cont.)
o Minimum waiting time is 3 seconds.
o Maximum waiting time is 18 seconds.
If no Glow-plug wire is found on the vehicle, the
Glow-plug input on the Remote Car Starter may
be “timed out”. The Remote Car Starter will power
up the Ignition and Glow-plug circuits and simply
wait for the time-out before starting:
• Connecting the Glow-plug input wire of the
Remote Car Starter to Ignition will hold the
ignition ON for the maximum waiting time (18
sec., recommended).
• Keeping the Glow-plug input wire of the Remote
Car Starter unconnected will hold the ignition
ON for the minimum waiting time (3 sec., not
recommended in very cold environments).
Connect the Glow-plug wire to the Ignition wire
only after the Tach programming has been
completed: connecting the Glow-plug wire is one
of the very last steps in the installation process.
2-Pin Harness
Wire Colour Function Description
1
BLUE/
WHITE
(–)
AUX 2
output
This 500 mA negative output can be programmed
for one of the following Options:
. Constant while the
LOCK and UNLOCK buttons are
pressed simultaneously, + 1 sec. after the
buttons are released.
. Pressing
LOCK and UNLOCK simultaneously
toggles the output
ON and OFF with automatic
toggle OFF after 30 seconds.
2 YELLOW
(–) Parking
Light output
500 mA negative Parking Light output.
Flashing the Hood Pin Switch
Flashing the Hood Pin switch is a procedure that brings the Remote Car Starter into Programming
Mode. Once the Remote Car Starter is in Programming Mode, the installer will have up to
20 seconds to select one of the sub-menus. If the installer fails to select a sub-menu before the 20-
second delay, the Remote Car Starter will exit Programming Mode and the installer will have to
flash the Hood Pin switch once more.
Tip
As long as the Hood is up, you may use the
Programming Assistance Button instead of the Hood
Pin switch.