Filter
Top Products
AS-1785 Installation Guide P. 23
2. Press and release the Break Pedal 6 times (within 10 seconds from entering
Programming Mode).
3. The Parking Lights will flash 8 times to confirm resetting.
Table 10: Resetting without a Valet Button
On some vehicles (such as BMW and certain Volkswagen vehicles), resetting will not work if the
Brake Pedal is pressed while the Ignition Key is not in the IGNITION ON (RUN) position: you will need
therefore to hot-wire the Brake Pedal by manually jumping 12 V with a fused test lead at the Brake
Pedal switch.
1. Flash the Hood Pin switch (see Table 1)
– Once inside Programming Mode, you have 10 seconds to complete the next step.
2. Press and release the Valet Button 6 times or more until the Parking Lights start to
flash.
3. The Parking Lights will flash 8 times to confirm resetting.
Table 11: Resetting with the Valet Button
Events Logging
With this feature, the Remote Car Starter will play back the last 4 Start Failure Events Codes and
the last Intrusion Code via the Parking Lights or L.E.D.
Events playback
Ensure that the Hood is up, that the vehicle is not in Valet Mode and that the Ignition is
OFF.
• Hold down the Hood Pin-switch for 4 seconds.
• Release the Pin-switch. The Parking Lights will come on.
• While the Parking Lights are on, immediately push the Pin-switch 3 more times
(down-up / down-up / down-up).
The Parking Lights and L.E.D. will flash the five events stored in memory.
Table 12: Events playback
The first four playback codes are Start Failure Events. There is a pause after each event code is
played back. The system will play back the most recent event first, then the second one, and so on.
If there is no event at all to report, the Parking Lights will give one long flash.
Start Failure Codes through the Parking Lights
1 x = No Start
3 x = Hardware Reset
4 x = Brakes
5 x = No Tach Cut-off
6 x = Hood
7 x = Engine Running, no Ignition detected, or Tach before Start
Note: “x” stands for one flash of the Parking Lights