Filter
Top Products
The RF-501 may be placed into the VALET (stand-by) mode to allow
for vehicle service, car washing, or attendant parking without
self arming after the ignition is switched off, and without leaving
the RF-501 transmitter with unauthorized individuals.
To enter the VALET mode, the vehicle ignition must be in the "ON"
position; then move the VALET/OVERRIDE SWITCH to "ON".
To return to normal operation, the vehicle ignition must be in the
"ON" position; then move the VALET/OVERRIDE SWITCH to
OFF.
NOTE: In the valet mode, the vehicle doors can be locked and
unlocked using the remote transmitter. However, there will be
no chirp confirmation; it is strongly recommended that the driver
visually confirm that the doors are locked.
E. PASSIVE/MANUAL ARMING OPERATION (OPTIONAL)
1. PASSIVE ARMING
If you choose the PASSIVE (automatic) mode, the system must be
operated as below.
1. If an optional passive/manual switch has been installed, then
move the switch to the ON position while the vehicle ignition is
ON.
2. Switch OFF vehicle ignition, exit vehicle, and be sure all protected
openings are closed.
3. The LED STATUS INDICATOR will begin FAST FLASHING and
the automatic arming timer will begin counting down.
4. If you re-open the exit, the LED will stop flashing.
5. Close the exit and the LED will start flashing again.
6. The RF-501 will count down for 30 seconds. After 30 seconds,
the siren will chirp 1 time indicating the RF-501 has armed.