Filter
Top Products
3. DELETING THE PRE-WARNING SENSOR CIRCUIT (IF
INSTALLED)
The RF-501 offers an option to pre-warn possible violators with siren
chirps before triggering the alarm. The alarm will trigger on the third
violation within 15 seconds.
To delete the pre-warning sensor, press the GREEN button again
within
5 seconds after arming. The siren will confirm deletion with a low
chirp.
NOTE: Deleted sensor(s) will return to normal operation upon
disarming the RF-501. Sensor(s) deletion procedure must be
followed
each time the RF-501 is armed if this function is desired. This
operation deletes only the pre-warning sensor of the alarm. For
maximum protection, sensor(s) may be installed on a separate alarm
circuit that will not be affected by the pre-warning deletion operation.
4. DELETING THE ARM/DISARM CHIRP
The arm/disarm chirp signal may be deleted in two ways. If permanent
arm/disarm chirp delete is chosen, open the access door on the RF-
501
main unit and set dip switch #2 to OFF. Consult your local dealer for
details.
If it is desired to control the arm/disarm chirp through the RF-501
transmitter, then the procedure outlined below must be followed.
1. Upon approaching the vehicle (whether armed or disarmed) push
the
BLACK button on the transmitter for a half (0.5) second, then very
quickly push the GREEN button on the transmitter to arm or disarm in