Auto Page AutoPage RF-501 Automobile Alarm User Manual


 
Each time the RF-501 is disarmed domelights will turn on for 60
seconds. Entering the vehicle after disarming, and switching on the
ignition will turn the dome lights off before the 60 second time limit
has expired.
NOTE: If the domelight supervision installation procedure (Section F,
Page 15) is not installed as shown, then the ignition control door lock
system may not work properly in your vehicle. In addition, the 60
second automatic rearm feature will not cancel by opening a door.
I. BREACH WARNING
The RF-501 is equipped with BREACH WARNING to tell you, upon
disarming, if the alarm has been triggered in your absence. Press the
GREEN button on the transmitter. If a breach has occurred, the siren
will signal with 4 chirps, the lights will flash four times, and the LED
will be flashing in a 2 second flash/hold sequence.
J. PANIC FUNCTION
The RF-501 transmitter may be used as a remote panic switch to
trigger the siren in cases of emergency. To activate the PANIC
FUNCTION press and hold the GREEN button on the transmitter for a
minimum of 3 seconds. The siren will sound. To stop the PANIC
FUNCTION press the GREEN button on the transmitter.
NOTE: PANIC FUNCTION on transmitters programmed for multiple
vehicle operation will vary according to which button has been
programmed for arm/disarm function on each vehicle.
K. TRIGGER TEST
After arming the RF-501 in either the PASSIVE or MANUAL mode, test
the system in the following manner.
1. Open any door or other protected opening. The siren will sound