Filter
Top Products
the usual manner. The chirp signal will be silenced only for this
particular operation. The sequence must be repeated each time if it is
desired to cancel the arm/disarm chirp signal.
2. Upon deleting the arm/disarm chirp signal, arm/disarm verification
may be made by watching the vehicle's lights flash.
5. TRUNK/HATCH RELEASE
To remotely release the electric trunk or hatch on the vehicle you
must first disarm the RF-501. After disarming push the BLACK button
on
the transmitter for THREE (3) seconds. Trunk or hatch will release and
open. NOTE: The alarm will not control mechanical/latch trunk release
mechanisms.
6. SECOND/THIRD CAR OPERATION
Refer to SECTIONS "(M)" and "(N)" of this operation manual. Arming
and disarming will be determined by how the transmitters have been
programmed for multiple vehicle operation.
7. CHANGING THE TRANSMITTER BATTERY
The RF-501 transmitter uses one (1) 12 volt miniature battery, #EL12,
#VR22, or Radio Shack #23-144. It will provide approximately one year
of operation before replacement is necessary.
To replace the battery, carefully remove the case screw located at the
end of the transmitter where the key ring attaches to the case. Use a
small blade Phillips screwdriver. Before removing the battery note the
direction of its terminals. Install the new battery exactly the same
using
caution so as not to bend, or otherwise damage the battery contacts.
Replace the case cover and carefully tighten the screw. DO NOT
OVER-TIGHTEN THE SCREW! Test the transmitter to insure it arms