Filter
Top Products
6
CONNECTING THE RELAY (HEAD LAMP FLASH
FEATURE)
IMPORTANT!
When using the relay to flash the
vehicle’s parking lights, unload the
BLACK wire from terminal 87A of
the relay harness and load it into
terminal 87. Refer to Figure 6.
1. Connect the ORANGE wire from the relay harness
to the WHITE wire from the main harness. Be sure
to insulate this splice with electrical tape. Refer to
Figure 6.
2. Gain access to the wires coming from the back of
the head lamp socket. Switch the head lamp on,
and locate the wire that measures + 12 volts on the
logic probe. Switch the head lamp off, and verify that
this wire now measures 0 volts. Cut this wire in half.
Connect the BLACK wire from the relay socket to
the headlight side of this wire and insulate the
connection with electrical tape. Connect the WHITE/
BLACK wire to the other side of the headlight wire.
3. Connect both the RED wire from the relay socket
and the WHITE/BLACK stripe wire from the relay
socket to a + 12 volt battery fused wire (minimum 15
Amp fuse) in the motorcycle. These wires can be
connected to the positive battery terminal, however
when connecting them to the positive battery termi-
nal, you must add an in line fuse of at least 15 Amps.
Connect one side of the fuse to the positive battery
terminal, and the other side of the fuse to the RED
and WHITE/BLACK stripe wires from the relay
connector.
PROGRAMMING THE KEYCHAIN TRANSMITTERS:
To Program the Transmitters:
1. Disarm the system by the manual override method or
by a pre-programmed transmitter
To Bike Harness
30
86
87a
85
87
To White
wire of siren
module
Orange
To Head Lamp
White/Black
Black
To fused 12V
constant source
FIGURE 6