Filter
Top Products
2
MOUNTING THE SIREN/CONTROL MODULE
1. Choose a location that is away from hot and mov-
ing parts considering the Red wire length must be
connected to the to the positive terminal of the bat-
tery. Prevent access to the siren as much as pos-
sible, by mounting in a hidden location. Typical
locations are underneath the gas tank, seat or ex-
terior body panels. Avoid areas which are sub-
jected to water, engine heat or grease.
2. The internal tilt sensor will be most sensitive when
the siren is oriented so that it is pointed toward the
front or rear of the motorcycle.
3. Once you have selected a location, inspect the area
to ensure that drilling the two required holes to
mount the bracket will not penetrate wiring or fluid
lines. Drill two 1/8" holes into the mounting sur-
face on the motor cycle. Attach the bracket using
the two screws provided. Mount the siren to the
bracket using the two screws provided. Point the
siren horn (front) downward or forward for the great-
est volume in the event of an alarm.
WIRING THE SIREN (Refer to Figure 1 Overall Wir-
ing Diagram)
RED:
Using the attached wire lug, connect the Red wire of
the siren to the positive terminal of the battery. If you
are familiar with your motorcycle's wiring, you may
use an alternate +12 volt constant source such as
the fuse panel or the ignition switch. Be sure to wire
the 1 Amp fuse (included) as close to the battery con-
nection as possible.
Congratulations on the purchase of your new Audiovox Alarm System. Taking a few minutes to
read this installation and owners guide will provide you with the detailed information concerning all the
features of your new alarm system.