Filter
Top Products
5
CONNECTING THE RELAY (STARTER/IGNITION)
IMPORTANT !
When using the relay to disable the
starter, leave the BLACK wire in ter-
minal 87a of the relay connector in
the location shown in the Figure 5.
1. Connect the ORANGE wire from the relay harness
to the ORANGE wire from the siren harness. Be
sure to insulate this splice with electrical tape.
Refer to Figure 5. Be certain to remove the series
resistor before connecting the relay.
2. Gain access to the wires coming from the ignition
switch. Connect the RED wire from the relay
harness to the wire from the ignition switch that
measures + 12 volts when the key is switched to
the "ON and START" positions, and measures 0
volts when the key is switched to the "OFF" posi-
tion. Be sure to insulate this connection with
electrical tape.
30
86
87a
85
87
X
Cut
To +12V in run
and crank
Orange
To Start solenoid
or ignition
Black
White/Black
To starter or ignition
wire from key
To Orange on
MA200
FIGURE 5
3. Locate the wire coming from the starter switch that
measures + 12 volts on the logic probe when the
starter motor is cranking, and measures 0 volts
when the key is switched to the "OFF" position. Cut
this wire and try to start the vehicle to verify that the
starter motor will not engage. You may also
interrupt the ignition circuit of the motorcycle if an
electric start wire is not available.
Connect the WHITE/BLACK stripe wire from the
relay harness to one side of the cut wire, and
connect the BLACK wire to the other side of the cut
wire.
CAUTION:
Be sure these wires are securely con-
nected, and properly insulated. If this
connection separates, the motorcycle
will not start or run, even when using the
ignition key.