Filter
Top Products
11
TROUBLESHOOTING:
Symptom:
The Transmitters will not program to the
control module.
Check:
1. Verify that the 1 Amp fuse in the red wire from the
siren control module is in good condition. Replace
it if it is blown.
2. Verify that the connections of the red and black
wires have been made according to the wiring
section of this manual.
4. The battery in the motorcycle and/or transmitter is
weak or dead. Change or replace the batteries as
needed.
Symptom:
The alarm will not arm and disarm using
the keychain transmitter.
Check:
1. Verify the transmitter battery is in good condition.
Replace the transmitter battery if necessary.
2. Verify that the transmitter is programmed to the
siren control module. Follow the programming in-
structions in this manual.
3. Verify that the 1 Amp fuse in the red wire from the
siren control module is in good condition. Replace
it if it is blown.
4. Verify that the connections of the red and black
wires have been made according to the wiring
section of this manual.
Symptom:
The override function will not disarm the
alarm.
Check:
1. The ignition key must be turned "ON" and "OFF"
five times within 20 seconds..
2. Verify the connections of the orange wire.