Filter
Top Products
Page 12
1
2
3
4
1
2
3
4
1st
2nd
This feature can be used if the vehicle is parked in an area with above average
noise or vibrations. (Airports, construction zone...)
To Temporally Bypass The Shock
Press the button #1 to arm the alarm then press button #3 within three seconds.
The system will chirp once when the lock button is pressed and once when the start
button is pressed. The shock sensor will be disabled until the system is disarmed
and the rearmed again.
Note: The shock sensor can be programmed by the remote transmitter. Hold
button #4 until the 1st program icon begins to flash the use button #1 to scroll to the
hammer symbol. Press button #2 to deactivate the shock sensor. To turn the sensor
back on select the hammer symbol and press the button #3.
Press and hold buttons #1 and #2 for three seconds. The park lights will flash
and the siren will three times.
While the park lights are on strike the vehicle with the amount of force wanted to
trigger the alarm*. Hit the vehicle with the same amount of force three time, the
siren will chirp each time the system detects the Impact.
*Strike the vehicle with the palm of the hand, be careful not to impact the vehicle in
a area that may cause damage. The most common location for testing and setting
the shock sensor is the A-pillar. The A-Pillar is the metal support that runs from the
roof of the vehicle to the hood area.
Temporary Shock Sensor Bypass
Shock Sensor Programming/ Adjustment
OWNER’S GUIDE 2way REMOTE STARTER/ ALARM