Filter
Top Products
QUICK START INSTALL
Program mode allows you to adjust the settings and options of your system.
Your system has been intelligently designed by installers with years of experience. The system’s default settings do not require any
program changes in most cases. However, this system does incorporate a highly advanced programming system that includes 4
menus with numerous options and settings that can be easily adjusted for custom installations and applications.
Menu 1 - User Settings - Page 8
This program menu contains settings that adjust the way the system operates for the user.
Menu 2 - Alarm Settings - Page 9
This program menu contains settings that adjust the way the system operates for the user.
Menu 3 - Starter Settings - Page 10
This menu controls features and settings associated with remote car starter applications.
Menu 4 - Tach Settings - Page 11
This menu allows the programming of the tach signal and the manual adjustment of that setting.
Programming Overview
Entering Program Mode
Changing the Programmable Settings
To Enter Program Mode
1) Make sure ignition is in the off position.
2) Within three seconds turn the key ON - OFF - ON - OFF - ON. Leave in the “ON” position.
3) Press and release the Program Button on the antenna one time.
4) The park lights will come on and the siren will chirp to confirm entering Program Mode.
5) Select the Desired Program Menu:
Press Button #1 Lock User Options Page 8
Press Button #2 Unlock Alarm Options Page 9
Press Button #3 Start Remote Start Options Page 10
Press Button #4 Aux Tach Adjustment Menu Page 11
6) The selected mode will be confirmed by a siren chirp and one park light flash.
7) The Program Menu may be changed at any time by pressing the transmitter buttons as above, this allows the installer to
change a setting from one menu, then quickly jump to another menu without re-entering the Program Mode.
8) To exit Program Mode, turn the ignition key “OFF” or wait 30 second and the system will exit automatically.
Note: If the unit does not enter Program Mode, turn the ignition off for five seconds and repeat steps 1-4.
** The first ignition(Blue wire) MUST be connected to the vehicle’s first ignition wire. If it is not connected it will not be possible to
enter the Program Modes.
To Select and Change A Program Setting:
1) Enter Program Mode.
2) Select the desired Program Menu. (See pages 8 - 11)
3) Press & release the Program Button the correct number of times to select the desired Program Setting(as listed on pages 8 -
11). The park lights will flash and the siren will chirp to indicate the current setting that is selected.
4) Press and hold the Program Button until the parking lights / siren confirm the selected setting. The park lights will flash and the
siren will chirp to indicate the option selected within the setting.
5) Turn the ignition key “Off” to exit Program Mode.
Note: This procedure is listed below each program setting on pages 8 - 11 of this manual.
SYSTEM RESET
STEP 1 - Within three seconds turn the key ON-OFF-ON-OFF-ON (Leaving Key ON).
STEP 2 - Press and release the Program Button.
STEP 3 -The park Lights will turn ON.
STEP 4 - Press and hold the program button again for 8 seconds until the park lights flash and the siren will chirps three times.
The system is now re-set to factory defaults.
Note: Reset to defaults resets the tach learning and any setting that may have been changed
in the program menus but does not delete the transmitters from memory.
INSTALLATION GUIDE
PROGRAMMING
PROGRAMMING