Filter
Top Products
Manual Transmission Remote Starters must have both the door trigger and park brake wires
connected. Most installs will require a clutch bypass. This is a temporary bypass. The clutch should
only be bypassed during the activation of the remote starter. Never disconnect or alter the switch to be
always bypassed. Always use a “M” Series Remote Starter on a manual transmission vehicle.
Never install a automatic Remote Starter model into a manual transmission vehicle. It is not
recommended to install a remote starter on a convertible type vehicle. If doing so It is highly
recommended that a radar sensor is installed to cover the proximity of the gear shift lever. If the radar
sensor is tripped the remote starter will exit Reservation Mode.
To enter Reservation Mode, the following steps must be followed.
Step 1 - While the vehicle is running, place the transmission in neutral and apply the parking brake.
Step 2 - Press and release the brake pedal. The park lights will activate.
Step 3 - Turn the ignition key off and the vehicle will stay running.
Step 4 - Exit the vehicle and close the door. The vehicle will then shut off.
Step 5 - The vehicle can now be safely remote started.
NOTE: If the vehicle has a dome light delay, the vehicle may stay running until the dome light turns off.
This is normally no longer than 30 seconds. Reservation Mode will automatically be exited if the doors
of the vehicle are opened. The set-up mode will then have to be repeated . Reservation Mode Must be
set-up each time the vehicle is parked.
Note: If the vehicle is not in Reservation Mode and the Start button is pressed, the system will
flash the park lights four times slowly.
Reservation Mode - Manual Trans.
Step 1 - Within three seconds turn the ignition Key ON-OFF-ON-OFF-ON - Leaving Key ON
Step 2 - Press and hold the Program button - Parking Lights will come ON **if park lights do not come
on at this point, turn key off for 5 seconds, the repeat step 1.
Step 3 - Continue to hold the Program button. The park lights will turn on.(Continue holding the Button)
Step 4 - Press the LOCK button on each of 1st car remote’s and press the # button on each of the
2nd car remote’s to be programmed. The park lights will flash once and the siren will chirp
once each time a new code is learned.
Note: Transmitter programming must done quickly. Do not pause more than one second between each
transmitter. All the transmitters to be used must be programmed at the same time. All transmitters
not programmed at this time will be erased from memory for security. The system holds a
maximum of 4 transmitter codes including 2nd car remote codes.
You can program the same remote as a 1st car remote in one vehicle and as a 2nd car remote in a
second vehicle.
+
-
Carefully remove the
screw from back of
the remote.
Remove top case
then replace the
battery.
Replace top case.
Re-install screw.
Test remote for
proper operation.
The transmitter battery should be changed at least once every year to maintain proper operating range.
Replace with quality23A 12volt Alkaline battery.
Transmitter Programming
Battery Replacement
OPERATIONS
OPERATIONS
INSTALLATION GUIDE