Ultra Start 2250M Automobile Alarm User Manual


 
INSTALLATION GUIDE
OPERATIONS
OPERATIONS
Remote Start
Remote Stop
Idle Mode
Turbo Timer Mode
Timer Mode
Self Learning Shock Sensor
1.Press and release the button.
2.The park lights will flash and the siren will chirp once.
3.When the vehicle has started, the system will flash the park lights four times and then
remain “On” while the vehicle is running.
4. The vehicle will continue to run for the programmed runtime. (normally 15 minutes).
EXTEND RUNTIME
1.Press and release the button while the vehicle is remote started.
2.The system will respond with one park light flash and one siren chirp to confirm Extended
Runtime. The system will reset the run time, (normally 15 minutes).
1.Press and hold the button for three seconds. The remote starter will shut down.
2.The park lights will flash two times and the siren will chirp two times.
Note: Pressing the brake pedal or opening hood will also stop the vehicle.
1.While the vehicle is running with key, press the button.
2.The park lights will turn on and the siren will chirp once.
3.Turn the ignition key “Off” and the vehicle will continue to run.
4. Exit the vehicle and leave it running safely without the keys in the ignition. Lock the door while the
vehicle is left running.
1.While the vehicle is running with key, press the # button.
2.The park lights will turn on and the siren will chirp once.
3.Turn the ignition key “Off” and the vehicle will continue to run for 2 minutes
1.Press and release the # button, then press and hold the button for six seconds, until
The parking lights turn “On”.
2.While the parking lights are “on” the start cycle can be selected.
1 hour cycle Press LOCK button 1 Park Light Flash
2 hour cycle Press UNLOCK button 2 Park Light Flashes
3 hour cycle Press button 3 flashes
4 hour cycle Press button 4 flashes
3.System will start vehicle at selected cycle for up to 24 hours.
To Cancel Timer Mode:
1.Press and release the # button, then press and hold the button for four seconds.
2.The park lights will flash and the siren will chirp twice.
3. Starting the vehicle with the key or by the remote will also cancel Timer Mode.
#
Press the lock button 5 times, once every half second or until the siren chirps 3 times and
the park lights turn. Strike the vehicle with the amount of force wanted to trigger the alarm.
Strike the vehicle 3 times to set the impact level. Each time the vehicle is impacted the
siren will chip. Press the unlock button to exit Shock Sensor Learning.
Reservation Mode (Manual Transmissions Only)
1. With the vehicle running, apply the park brake then press and release the brake pedal.
2. The park lights will flash and the siren will chirp to confirm that reservation mode has been activated.
3. Remove the key from Ignition, and exit the vehicle. (the vehicle will remain running)
4. Close the door and the vehicle will shut off.*
*If the vehicle has a delay dome-light, the vehicle may run until the dome-light turns off.
5. The vehicle is now in Reservation Mode and may be remote started.
Note: Opening a door after this point will cancel Reservation Mode.
1.Press and release the LOCK button. The siren will chirp once.
2.Within 3 seconds press and release the Button the siren will chirp once.
*This feature can be used in bad weather or in areas with high levels of noise (Airports....)
Note: The shock sensor will reset the next time the alarm is armed.
Temporary Sensor Bypass
1st
2nd-6 sec.
3 sec.
While
running
Press &
Release
While
running
Press 5
Times
2nd
1st