Filter
Top Products
G
ELECTRICAL
G - 11
SATELLITE ANTENNA WIRING
If you compare the two drawings you’ll see wiring for a satellite dish an-
tenna is relatively simple.
Units have a faceplate with two coax cable hook-
ups. The faceplate has a small coax cable jumper
running between the hook-ups to complete the cable
TV circuit when in use. To install a satellite system
use the following procedure:
1. Remove the jumper wire from the coax faceplate.
2. Hook a portable dish into the Cable TV receptacle in the roadside rear
underbelly compartment. This feeds the dish signal to the input side of
the faceplate.
3. Install the satellite receiver input and output into the dual coax faceplate.
To return to a cable TV system, remove the satellite receiver from the face-
plate and reinstall the jumper cable.
COAXIAL CABLE WITH CABLE HOOK UP
CO
AXIAL CABLE WITH SATELLITE HOOK UP
Exterior Cable TV Hook Up
Exterior Cable TV Hook Up
Dual Coax
Faceplat
e
Dual Coax
Faceplat
e
Jumper
Cabl
e
TV
TV
TV
TV
Satellite Antenna
Front TV Jack
W/Booste
r
Front TV Jack
W/Booste
r
Satellite
Reciev
er
TV Antenna
TV Antenn
a
Antenna Lead in
Antenna L
ead in
Satellite
Jumper Wire