Filter
Top Products
AT Commands
62 Cingular GPRS Raven User Guide Version 2.01
TABLE 1. Information and Status
Command Details
I[n]
n=0 Product name (i.e. Raven).
n=1 The Raven’s firmware (ALEOS) version, hardware
ID, and copyright.
n=2 The OEM module's firmware version and relevant
hardware ID.
n=3 The OEM module's unique ID (ESN).
&V View active profile (the contents of the active registers).
*HOSTMODE? The current host mode (AT, PPP, UDP, etc.). If the Raven
is not in AT mode, telnet into the modem to execute this
command.
*NETCHAN? The current active GPRS channel number .
*NETERR? The network bit error rate.
*NETIP? The current IP address of the modem reported by the
embedded OEM module (generally obtained from Car-
rier). This is the address to which packets can be sent in
order to contact the Raven from the Internet. Note: If there
is no current network IP, 0.0.0.0 may be displayed.
Use *NETALLOWZEROIP if you need to allow the dis-
play of an IP ending in a zero. See “*NETALLOWZE-
ROIP=n” on page 79.
*NETOK Checks the GPRS network connection.
OK if connected.
ERROR if not connected.
*NETOP?
The current network operator (cellular carrier, i.e.
Cingu-
lar
) from the modem's firmware version.
*NETPHONE? The modem's phone number (if applicable or obtainable).
*NETRSSI? The current RSSI (Receive Signal Strength Indicator) of
the Raven as a negative dBm value. The same information
is displayed with the command S202?.