Filter
Top Products
AT Commands
92 Cingular GPRS Raven User Guide Version 2.01
S3=n
n=0-127
(ASCII charac-
ter number)
Carriage Return Character
The standard end of line character used to indicate the
end of an AT command. This character is also used as
the carriage return character for framing responses and
result codes in command state.
S4=n n=0-127
(ASCII charac-
ter number)
Line Feed Character
The standard line feed character sent by the modem to
the host at the end of a response or return code in com-
mand state.
S5=n n=0-127
(ASCII charac-
ter number)
Backspace Character
This register sets the character recognized as a back-
space during command entry
S6=n n=2-10 Wait for Blind Dial
This register denotes the wait time, in seconds, before a
blind dial (no dial tone detection).
S7=n n=1-255 Wait For Carrier
If no carrier from the remote modem is detected within
the specified time, the modem goes on-hook.
S8=n n=0-255 Comma Pause Time (Dial Modifier)
Whenever a dial command contains the comma charac-
ter, the contents of this register specify the pause time for
each comma.
S9=n n=0-255 Carrier Detect Response Time
Specifies the time that the received carrier must be
present for the modem to recognize it and turn on Data
Carrier Detect (DCD) if applicable. The implementation
is entirely at the IWF modem.
S10=n n=1-2545 Lost Carrier Hang-up Delay (Remote)
Specifies the amount of time that the carrier from the
remote modem can be lost before the modem goes on-
hook. This allows temporary disruptions to carrier with
-
out disconnecting.
A setting of 255 causes the modem to disable Carrier
Detect and presume carrier is always present.
TABLE 19. Commands Usable with PassThru
Command Parameters Details