Filter
Top Products
Please refer to the section “3M™
Dynatel™ Locator Setup” for more details on
how to setup the Locator.
Connect the Trimble™ GeoXT™ to the 3M™ Dynatel™ M-series Locator using a
standard DB9 cable as provided with the 3M
™ Dynatel™ Locator.
Do not use the “null” modem adapter!
1. Open the GPS Connector application on the Trimble
™ GeoXT™.
2. Turn on the 3M™ Dynatel™ M-series Locator and go to the marker locate
mode. If the GPS unit is disconnected or has not acquired enough
satellites to give a position, the 3M™ Dynatel™ Locator will display "Insert
External Device".
3. After the GPS unit has acquired a position, the 3M™ Dynatel™ Locator
will display the latitude and longitude coordinates.
4. When a marker has been located and the GPS device has acquired a
position with adequate precision for your needs, press the Read key on
the 3M™ Dynatel™ Locator.
When an iD marker is read, the marker data and GPS coordinates will be
displayed and saved to the Locator's memory. This data can be uploaded into
PC Locator tools and added to your database.
Trimble™ GeoXT™ / 3M™ Dynatel™ Mode 2 (GIS)
Set up the external sensor as follows:
1. Open the Terrasync™ application. Tap Start, Programs, Terrasync™.
2. Tap the Section List in the upper left hand corner and select Setup.
3. Tap External Sensors settings then tap Properties. Enter "Dynatel M-
Series".
4. Set up Communications as follows:
Port: COM 1
Baud Rate: 4800
Data Bits: 8
Stop Bits: 1
Parity: None
5. Set up Data Identification as follows:
Prefix String blank, no spaces.
Suffix String blank, no spaces.
Max Bytes 100
Time Out 0.10s
Receive Mode Unsolicited
Point Feature All
Line/Area Feature Off
Not in Feature: All
Data Destination As Attribute
Attribute Name: iD Data
21