29
Kiosk Modifications of the OLE for Retail POS
General Information
11/25/2013 OPOS Driver User Guide P1061668-001 Rev. A
Data Characters and Escape Sequences
The following escape sequences are recognized. If an escape sequence specifies an operation
that is not supported by the printer station, then it is ignored.
One Shots Perform indicated action.
Table 9 • One Shot Data Characters and Escape Sequences
Name Data Remarks
Zebra Kiosk
Printer Supported
Paper cut ESC |#P Cuts receipt paper. The character ‘#’
is replaced by an ASCII decimal
string telling the percentage cut
desired. If ‘#’ is omitted, then a full
cut is performed. For example: The C
string “\x1B|75P” requests a 75%
partial cut.
For a full cut use
ESC|100P.
Use ESC|50P if you want
to use Hold Page in the
Windows driver.
Feed and Paper cut ESC |#fP Cuts receipt paper, after feeding the
paper by the RecLinesToPaperCut
lines. The character ‘#’ is defined by
the “Paper cut” escape sequence.
See Paper cut.
Use ESC|100P.
This command is not
working as expected
when used with the
Windows printer driver
and the paper advance at
the end before cut has to
be setup in the Driver’s
Printing Preferences
under Advanced settings.
Feed, Paper cut, and
Stamp
ESC |#sP Cuts and stamps receipt paper, after
feeding the paper by the
RecLinesToPaperCut lines. The
character ‘#’ is defined by the “Paper
cut” escape sequence.
NO
Fire stamp ESC |sL Fires the stamp solenoid, which
usually contains a graphical store
emblem.
NO
Print bitmap ESC |#B Prints the pre-stored bitmap. The
character ‘#’ is replaced by the bitmap
number. See setBitmap method.
YES
Note • This command
will be ignored in Left90
rotation.
Print top logo ESC |tL Prints the pre-stored top logo. NO
Print bottom logo ESC |bL Prints the pre-stored bottom logo. NO
Feed lines ESC |#lF Feed the paper forward by lines. The
character ‘#’ is replaced by an ASCII
decimal string telling the number of
lines to be fed. If ‘#’ is omitted, then
one line is fed.
YES
