English
E-7
7
SUBWOOFER level control
This control is used for adjusting the level of sound
outputted from the subwoofer. Turn this control
clockwise to increase the level, and counterclockwise
to decrease the level.
8 MASTER VOLUME control
This control is used for adjusting the whole volume
level of this system. Turn this control clockwise to
increase the level, and counterclockwise to decrease
the level.
9 Headphone jack
Stereo headphones can be connected to this mini-jack
for private listening. Sound output from the speakers
are cut off when headphones are connected to this
jack.
Sounds of all channels are mixed into 2-channels and
outputted from the headphones.
0 Power indicator
Lights up when the power of this system is on.
A Power switch
Each press of this switch changes the status of this
system between standby mode and power on. When
the power is on, the power indicator (0) lights up.
* Note that this system uses a small amount of power
in the standby mode.
B SPEAKER OUTPUTS
FRONT:
Connect one satellite speaker with a 3 m cord to the L
terminal and another to the R terminal. They are used
as the front speakers.
SURROUND:
Connect one satellite speaker with a 7 m cord to the L
terminal and the other to the R terminal. They are used
as the surround speakers.
CENTER:
Connect one satellite speaker with a 3 m cord to this
terminal. It is used as the center speaker.
C SPEAKER MODE switch
Normally, set this switch to 5CH. According to your
preference, set this switch to another position.
5CH:
All speakers are used in this mode.
4CH:
Select this position when you will not use the center
speaker. In this mode, center sound is outputted from
the front L and R speakers.
2CH:
Select this position when you wish to output sounds in
2-channels only. In this mode, sounds of all channels
are mixed and outputted from the front L and R
speakers. The surround speakers output the same
sounds as the front speakers.
D DC IN connector
Connect the supplied AC adaptor to this connector.
E DIGITAL INPUTS
External units which has digital signal output terminals
can be connected to these terminals.
Input signals received at the OPTICAL terminal have
priority over the signals at the COAXIAL terminal.
When both terminals receive signals, the signals at the
OPTICAL terminal are reproduced with this system.
OPTICAL:
Connect an external unit (a DVD/CD player, an MD
recorder, a video game player, etc.) which has an
optical digital signal output terminal to this terminal by
using the supplied optical cable.
COAXIAL:
Connect an external unit (a DVD/CD player, an MD
recorder, a video game player, etc.) which has an
coaxial digital signal output terminal to this terminal by
using the supplied coaxial cable.
F ANALOG INPUTS
Connect analog signal output terminals of an external
unit to these mini-jack terminals by using the supplied
mini plug cables or commercially available pin-to-mini
plug cables.
FRONT:
Connect an analog (stereo) signal output terminal of an
external unit to this terminal by using a supplied mini
plug cable. When you connect a sound board on a
computer which has four channel output terminals,
connect the front channel output terminal of the sound
board to this terminal.
SURROUND:
When you connect a sound board on a computer which
has four channel output terminals, connect the rear
channel output terminal of the sound board to this
terminal.
SR601ENG(9/29)e 00.9.29, 2:34 PM7
