English
E-5
Ⅵ Adjusting the front angle of the satellite
speakers
The front angle of the satellite speakers can be adjusted as
shown below.
1 Loosen the screw on the bottom of the speaker stand.
* Put the supplied nonskid pads at the four corners on
the bottom of the stand to obtain more stability.
2 Slide the speaker on the stand as you prefer, and then
tighten the screw.
Ⅵ Mounting satellite speakers on a wall
The satellite speakers can also be hung on the wall.
Fasten screws into a firm wall or wall support as shown in
the figure, and hang the slits on the rear of the speaker on
the protruding screws.
* Make sure that the screws are securely caught by the
slits.
Warning
● Each speaker weighs 0.4 kg (0.9 lbs.). Do not mount them
on thin plywood or a wall with soft surface material. If
mounted, the screws may come out of the flimsy surface
and the speakers may fall. This damages the speakers or
causes personal injury.
● Do not install the speakers to a wall with nails, adhesives, or
any other unstable hardware. Long-term use and
vibrations may cause them to fall.
● To avoid accidents resulting from tripping over loose
speaker cords, fix them to the wall.
Tapping screw (4 mm)
(Available at the hardware store)
50 mm
Min.
20 mm
4 mm
Pads
Wall/ wall
support
Pads
Ⅵ Mounting a center speaker on top of the
monitor
When placing the center speaker on top of the monitor,
remove the stand from the speaker, and put the provided
fastener at the bottom of the speaker and on top of the
monitor to prevent the speaker from falling.
* Do not mount the speaker on top of the monitor with an
inclination to a level surface of more than 10 degrees.
Note
Though this speaker is a magnetically shielded type, there
may be some influence on a monitor picture depending on the
type of monitor or the placement of the speaker. In such a
case, place the speaker apart from the monitor so that there is
no influence on the monitor picture.
Ⅵ Mounting the amplifier unit on the supplied
stand
To obtain stability, it is recommended to mount the amplifier
unit to the supplied stand with the supplied screws as
shown below.
* Put the supplied nonskid pads at the four corners on the
bottom of the stand to obtain more stability.
Now making an
illustration
SR601ENG(9/29)e 00.9.29, 2:34 PM5
